MaxTech 800 Manual do Utilizador descarregar pdf (Página 7)

REV. 1 MC

13616 Hempstead Road · Houston, Texas 77040 · (713) 460-5200 · (800) 460-5200

Fx: (713) 460-1444 · Fx: (800) 460-5700 · www.gaumer.com · [email protected]

Page 7 of 8

Hz Frequency. 50 or 60

Level 4 Parameters

Changing these parameters turns on and off access to the various controller functions. These parameters

should only be accessed by a Gaumer Process Heater representative or distributor. To access these

parameters, go to the LCK parameter in level 2 and set it at 1111, then press and hold the set key for 5

seconds. Setting a digit at 1 turns the function on, setting it at 0 turns it off.

First Digit Second Digit Third Digit Fourth Digit

SEt1 Alarm 2 Alarm 1 Auto Tuning Output Percentage

SEt2 Second Outupt analog

zero and span

Lower and upper

setpoint limit

Analog zero, span,

decimal point

Alarm 3

SEt3 Alarm time 2 Alarm mode 2 Alarm time 1 Alarm mode 1

SEt4 Low and high

calibration

Hysterisis of alarm Alarm time 3 Alarm mode 3

SEt5 ID no and Baud rate Motor timer, wait

mode, motor

hysterisis

Output 2 low and high

calibration

Transmitter low and

high calibration.

SEt6 Soft filter Temperature units PV compensation SV compensation

SEt7 Frequency Control Action Action mode Cascade

SEt8 Do not change! In program mode,

0=Start from 0,

1=Start from PV

In program mode

0=No power failure,

1=with power failure

In program mode

0=No repeat,

1=Program repeat

SEt9 Transmitter PV Transmitter SV Transmitter MV1 Remote SV

Table 1 Input Ranges

Type Code Range

K K1 0-200 C; 0-392 F

K K2 0-400 C; 0-752 F

K K3 0-600 C; 0-1112 F

K K4 0-800 C; 0-1472 F

K K5 0-1000 C; 0-1832 F

K K6 0-1200 C; 0-2192 F

J J1 0-200 C; 0-392 F

J J2 0-400 C; 0-752 F

J J3 0-600 C; 0-1112 F

J J4 0-800 C; 0-1472 F

J J5 0-1000 C; 0-1832 F

J J6 0-1200 C; 0-2192 F

R r1 0-1600 C; 0-2912 F

R r2 0-1769 C; 0-3216 F

S S1 0-1600 C; 0-2912 F

S S2 0-1769 C; 0-3216 F

1 2 3 4 5 6 7 8

Comentários a estes Manuais

Sem comentários

MaxTech 800 Manual do Utilizador Página 7

Comentários a estes Manuais

Manuais e produtos relacionados com Redes MaxTech 800