MaxTech NX-16 Guia do Utilizador

User's GuideNX-16 SeriesHigh PerformanceSoftware Configurable16-bit ISANE-2000 compatibleEthernet AdaptersPart #MAN005 Rev. 1.1

8README.TXT file describing the driver. Refer tothe RELEASE.TXT file on the installation diskettefor more information on the available drivers.Section

94.2 Cable ProblemsA) Observe the green Link Status LED ifyou are using a 10Base-T network. Turn on thecomputer. Connect the network cable and observe

10must use solid copper conductors and UL codesCM, CMR, and CMP are required. The computeron the network is connected via a star topology (i.e.each no

11Section Seven - Technical SupportIn the unlikely event you experience difficulty in the use of theproduct, or if it does not operate as described, w

12(also enclose a check for out-of-warranty repair). En-close your check or Postal Money Order for $7.50 tocover the cost of return shipping/handling.

Please take a moment to note the following infor-mation. Include this form in the unlikly event thatyou need to return the product for warranty servic

1ContentsSection One - Introduction... 1Section Two - Installation... 2Section Three - Driver Installati

2Minimum hardware requirements are anIBM PC/XT (or better) fully compatible PC with512K RAM running DOS 3.3 or higher. Thenetwork operating system you

32.2 Hardware InstallationInstallation of this adapter card requiresopening and manipulating your PC. Exercise cau-tion at all times when working with

46. Carefully install the adapter by firmly press-ing the card into the slot you have chosen,applying even pressure until the adapter iscompletely sea

5Running the SETUP program1. Insert the installation diskette into yourdrive, log on to that drive, and run theSETUP program in the \DIAG subdirectory

62.4 Testing The AdapterThe SETUP program provides an optionin its main menu for adapter diagnostics. One ormore PCs on the network can run the test s

7sure that the notch on the ROM matchesthat on the socket (refer to Figure 2).2. Configure the adapter using the SETUPprogram to enable the Boot ROM f