MaxTech 800 Manual do Utilizador descarregar pdf (Página 5)

866.4.Maxtec www.maxtecinc.com III

CAUTION:

Indicates a potentially hazardous situation, if not avoided, could result in minor or

moderate injury and property damage.

• The MaxVenturi is intended for use with speciﬁc patient interface conﬁgurations. The numbered

scale is intended for use with the Fisher & Paykel* heated humidiﬁer (MR850) and the Optiﬂow

high ﬂow patient interface system (OPT544, OPT546, OPT570). The lettered scale (Labeled A

through F) is intended for the alternate patient circuits found on the chart provided in Section 2.

• Never install the sensor in a location that will expose the sensor to patient exhalation

or secretions.

• Only use Maxtec approved accessories and replacement parts. Failure to do so may seriously

impair the MaxVenturi’s performance. Repair or alteration of the MaxVenturi beyond the scope

of the maintenance instructions or by anyone other than authorized Maxtec service personnel

could cause the product to fail to perform as designed.

• Use of the MaxVenturi near devices that generate strong electrical ﬁelds may cause

erratic readings.

• This device has a visual low-battery alarm but no audible alarm.

• Calibrate the MaxVenturi weekly when in operation or if environmental conditions change

signiﬁcantly, i.e., Temperature, Humidity, Barometric Pressure. (refer to Calibration sections of

this manual).

• The device will assume a percent oxygen concentration when calibrating. Be sure to apply

100% oxygen or room air concentration to the device during calibration or the device will not

calibrate correctly. (See section 2.2)

• Do not use ethylene oxide sterilization. Do not immerse the device in any cleaning solution,

autoclave or expose the device to high temperatures.

• Use with any other patient interface system may result in false readings from the

ﬂow meter.

• The MaxVenturi is not intended for steam, ethylene oxide or radiation sterilization.

• Do not clean with ethanol or acetone.

• After cleaning, and before use on a patient, attach the device to an oxygen supply and allow the

device to run at high ﬂow for several minutes to allow any cleaning ﬂuids or vapors to evaporate

and be ﬂushed out.

• The device can leak excess oxygen out the entrainment port if the oxygen control knob is

turned up too high. This can lead to a minor drop in total air ﬂow to the patient and excess

oxygen entering the room environment.

• Federal Law (USA) restricts this device to sale by or on the order of a physician.

ATTENTION:

Indicates a potentially hazardous situation, which, if not avoided could result in

property damage.

• If the MaxVenturi is ever exposed to liquids (spills or immersion) or to any other physical abuse,

return to Maxtec for evaluation before use.

• Always remove the batteries to protect the unit from potential leaky battery damage when the

unit is going to be stored or not in use for periods exceeding 1 month. Replace dead batteries

with high quality AA Alkaline batteries.

• Do not use rechargeable batteries with this device.

• Maxtec cannot warranty any damage resulting from misuse, unauthorized repair or improper

maintenance of the instrument.

• This product is Latex free.

• Avoid usage in environments with greater than 95% relative humidity.

*Maxtec, LLC. is not afﬁliated with Fisher & Paykel.

1 2 3 4 5 6 7 8 9 10 ... 20 21

Comentários a estes Manuais

Sem comentários

Modelle	Dokumententyp
PIN100	Installationsanleitung Porter-Cable PIN100 Installation Guide, 13 Seiten
PIN138	Installationsanleitung Porter-Cable PIN138 Installation Guide, 45 Seiten
PIN138C2002	Gebrauchs- und Pflegehandbuch Porter-Cable PIN138C2002 Use and Care Manual, 52 Seiten

MaxTech 800 Manual do Utilizador Página 5

Comentários a estes Manuais

Porter-Cable Nagelpistole Benutzerhandbücher

MaxTech 800 Manual do Utilizador Página 5

Comentários a estes Manuais

Manuais e produtos relacionados com Redes MaxTech 800

Porter-Cable Nagelpistole Benutzerhandbücher